GOODRICH Stormscope Series II, Руководство по установке

Страница: 29 / 65

WX-950
Installation Manual
2-14
Rev. C
The sub-cable color-coded jackets and shields should be left on the sub-cables as close to the connector as
practical to provide the required shielding and to identify the sub-cables. Guidelines for preparing the cable
for connection to the WX-950 mating connector (see paragraph 2-8) are shown in figure 2-9. Ground the
overall shield at both ends. The WX-950 End should be grounded within the mating connector assembly.
Ground the sub-cable shields only at the mating connector subassembly. Cable routing and length are not
critical to system operation.
Figure 2-9. Heading Input Cable Preparation
Tables 2-2 and 2-3 provide heading source interconnect information. Refer to the applicable manufacturers
publication for specific interconnect guidelines to be followed.
NOTE
Every effort has been made to correctly identify the pin numbers and signal names used
by the various manufacturers. However, Goodrich Avionics Systems cannot be
responsible for changes made by others. Please consult the appropriate manufacturers
documentation for the latest information.
Table 2-2. Stepper Input Connections
(KI-525 Indicator)
WIRE COLOR BACKSHELL KI-525
SIGNAL SUB-CABLE WIRE PIN NUMBER INDICATOR
WHITE WHITE 5 N/C
WHITE BLUE 4 N/C
DRIVE MOTOR 1 WHITE ORANGE 17 P2-A (BOTTOM)
HDG FLAG + ORANGE WHITE 6 FLAG +
HDG FLAG - ORANGE BLUE 19 FLAG -
UNREG +15 BLUE WHITE 16 P1-v (TOP)
DRIVE MOTOR 3 BLUE BLUE 3 P2-H (BOTTOM)
SIGNAL GND* GROUND
P1- j (TOP)
*Connect outer shield at KI-525, P1- j (TOP)