4. PLAYER MAINTENANCE
Cleaning the Cabinet
Wipe with a soft cloth. If the cabinet is very dirty, dampen the cloth with a weak solution of
neutral detergent and water, and then wipe clean.Disconnect AC adaptors before cleaning.
Cleaning the Lens
A dirty lens will cause sound skipping and, if the lens is very dirty, the CD may not work.
Open the disc cover and clean the lens as follows:
Dust or Dry Particles
Using a camera lens brush/blower, blow on the lens couple times, then wipe it lightly with
the brush to remove dust. Then ,blow on the lens once more.
Finger Prints
If the lens cannot be cleaned by using a brush/blower, use a dry cotton swab starting in the
middle and working to the outside edge.
5.DISC CLEANING AND TROUBLESHOOTING GUIDE
Cleaning the Disc
When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the centre out.
Note:
Do not use solvents such as benzine petrol, thinner, commercially available cleaners or
anti-static spray intended for analogue discs.
Should you experience difficulties in the use of this player please refer to the following
chart before contacting your dealer or the place of purchase.
Troubleshooting Guide
Problem
Points to Check
Player fails to function
Disc may be inserted upside down
Disc not mounted correctly on chuck
Dirty or defective disc
Dirty pick up lens
Player lid not closed
Moisture/condensation allow player to warm up to room
temperature for 60 minutes.
AC Power to adaptor switched off
Weak batteries
Auto power off has occurred
No sound from earphones
Earphone plug is not firmly inserted into the PHONES socket
Volume control is set to zero
No sound when played
Connection is incorrect
through an external amplifier
Power to external amplifier not switched on
Intermittent sound
Dirty or defective disc
Dirty pick up lens
Player is subject to excessive vibration
Low battery power
Poor earphone connection
