Goodman MBVC 1 Series, Руководство по установке

Страница: 2 / 24

2
Introduction
This booklet contains the installation and operating instructions for
your modular blower cabinet. All warnings and precautions within
this booklet must be observed. Improper installation can result in
problems ranging from noisy operation to property or equipment
damages, dangerous conditions that could result in injury or per -
sonal property damage and that are not covered by the warranty.
Read this booklet and any instructions packaged with accessories
prior to installation. Give this booklet to the user and explain its
provisions. The user should retain this booklet for future reference.
Electrostatic Discharge (ESD) Precautions
NOTE: Discharge body’s static electricity before touching unit. An
electrostatic discharge can adversely affect electrical components.
Use the following precautions during modular blower installation
and servicing to protect the integrated control module from dam -
age. By putting the modular blower, the control, and the person
at the same electrostatic potential, these steps will help avoid
exposing the integrated control module to electrostatic discharge.
This procedure is applicable to both installed and uninstalled (un -
grounded) blowers.
1. Disconnect all power to the blower. Do not touch the
integrated control module or any wire connected to the
control prior to discharging your body’s electrostatic charge
to ground.
2. Firmly touch a clean, unpainted, metal surface of the
modular blower near the control. Any tools held in a
person’s hand during grounding will be discharged.
3. Service integrated control module or connecting wiring
following the discharge process in step 2. Use caution not
to recharge your body with static electricity; (i.e., do not
move or shuffle your feet, do not touch ungrounded objects,
etc.). If you come in contact with an ungrounded object,
repeat step 2 before touching control or wires.
4. Discharge your body to ground before removing a new
control from its container. Follow steps 1 through 3 if
installing the control on a blower. Return any old or new
controls to their containers before touching any ungrounded
object.
Checking Product Received
Upon receiving the unit, inspect it for damage from shipment.
Claims for damage, either shipping or concealed, should be filed
immediately with the shipping company. Check the unit model
number, specifications, electrical characteristics and accessories
to determine if they are correct. In the event an incorrect unit is
shipped, it must be returned to the supplier and must NOT be in -
stalled. The manufacturer assumes no responsibility for installation
of incorrectly shipped units.
Replacement Parts
Ordering Parts
When reporting shortages or damages, or ordering repair parts,
give the complete unit model and serial numbers as stamped on
the unit’s nameplate.
Replacement parts for this appliance are available through your
contractor or local distributor. For the location of your nearest dis -
tributor, consult the white business pages, the yellow page section
of the local telephone book or contact:
HOMEOWNER SUPPORT
GOODMAN MANUFACTURING COMPANY, L.P.
19001 KERMIER ROAD
WALLER, TEXAS 77484
(877) 254-4729
Important Safety Instructions
Recognize Safety Symbols, Words, and Labels
The following symbols and labels are used throughout this man -
ual to indicate immediate or potential hazards. It is the owner’s
responsibility to read and comply with all safety information and
instructions accompanying these symbols. Failure to heed safety
information increases the risk of property damage, product damage,
personal injury or death.
HIGH VOLTAGE!
D
ISCONNECT
ALL
POWER BEFORE SERVICING
.
M
ULTIPLE POWER SOURCES MAY BE PRESENT
. F
AILURE
TO DO SO MAY CAUSE PROPERTY DAMAGE
,
PERSONAL
INJURY OR DEATH
.
WARNING