Goodman GPG10360901A, Руководство пользователя

Страница: 2 / 8

SIGNAL WORDS
Dear Homeowner, please recognize the following safety information.
This information will alert you to the potential for personal injury.
WARNING - Indicate hazards or unsafe practices which COULD
result in severe personal injury or death.
- Indicate hazards or unsafe practices which COULD
result in minor personal injury or product or property damage.
THIS PRODUCT CONTAINS OR PRODUCES A CHEMICAL OR CHEMICALS WHICH
MAY CAUSE SERIOUS ILLNESS OR DEATH AND WHICH ARE KNOWN TO THE
STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER
REPRODUCTIVE HARM.
TO AVOID POSSIBLE EQUIPMENT DAMAGE, PERSONAL INJURY, FIRE OR
DEATH, THE FOLLOWING INSTRUCTIONS MUST BE OBSERVED REGARDING UNIT
LOCATION, AIR REQUIREMENTS AND OPERATING PROCEDURES.
HEATING UNIT SHOULD NOT BE UTILIZED WITHOUT REASONABLE, ROUTINE,
INSPECTION, MAINTENANCE AND SUPERVISION. |F THE BUILIDNG IN WHICH ANY
SUCH DEVICE IS LOCATED WILL BE VACANT, CARE SHOULD BE TAKEN THAT
SUCH DEVICE IS ROUTINELY INSPECTED, MAINTAINED AND MONITORED. IN THE
EVENT THAT THE BUILDING MAYBE EXPOSED TO FREEZING TEMPERATURES
AND WILL BE VACANT, ALL WATER-BEARING PIPES SHOULD BE DRAINED, THE
BUILDING SHOULD BE PROPERLY WINTERIZED, AND THE WATER SOURCE
CLOSED. IN THE EVENT THAT THE BUILDING MAY BE EXPOSED TO FREEZING
TEMPERATURES AND WILL BE VACANT, ANY HYDRONIC COIL UNITS SHOULD
BE DRAINED AS WELL AND, IN SUCH CASE, ALTERNATIVE HEAT SOURCES
SHOULD BE UTILIZED.
IMPORTANT NOTE TO THE OWNER
It is important that you fill out the owner's registration card and mail it
today. This will assist us in contacting you should any service or
warranty information change in the future. When filling in the registra-
tion card, be sure to include the Model, Manufacturing and Serial
Numbers, plus the installation date. If the registration card cannot be
located, please call 1-877-254-4729 to register the furnace.
Your warranty certificate is also supplied with the unit. Read the
warranty carefully and note what is covered. Keep the warranty
certificate in a safe place, so you can find it, if necessary.
Before using this manual, check the serial plate for proper model identifica-
tion.
The installation and servicing of this equipment must be performed by
qualified, experienced technicians only.
GENERAL INFORMATION
UNIT LOCATION
This unit is approved only for an outdoor installation. See the installa-
tion instructions for the required clearances to the unit. It is important
that safety measures are taken in the surrounding area of the unit.
Gutters or deflectors must be installed on the roof to prevent water
from shedding on the unit.
1. An area must be available to reach the unit in a clear and unob-
structed path.
2. The unit area and the vicinity of any other gas appliances must
be kept clear and free of combustible materials, gasoline, and
other flammable vapors and liquids. Also, do not store or use
flammable items such as paint, varnish, or lacquer in the area.
3. The combustion air supply must not be contaminated by prod-
ucts containing chlorine or fluorine, as they could corrode the
heat exchanger. If you need further information on this subject,
contact your installing dealer or another qualified servicer.
4. Familiarize yourself with the controls that turn off the gas and
electrical power to the unit.
5. Establish a regular service and maintenance schedule to ensure
efficient and safe operation of the unit.
6. The unit must be placed where no run off water from higher ground
can collect in the unit.
UNIT INSTALLATION
Examine the unit installation to determine the following:
1. The flue hood connector is in place and is physically sound with-
out holes or excessive corrosion.
2. The mounting pad support of the unit is sound.
3. There are no obvious signs of deterioration of the unit.
4. The burner flames are stable, soft and blue, (dust may cause
orange tips but must not be yellow). The flames should extend
directly outward from the burner without curling, floating, or lifting
off. To examine, turn on the electrical power and gas. Set the
room temperature to the maximum setting.
Burner
NOTE: If a strong wind is blowing, it may not be possible to perform
the flame inspection.
TO AVOID PERSONAL INJURY OR FIRE, MINIMUM CLEARANCES TO
COMBUSTIBLE SURFACES MUST BE FOLLOWED.
A I R REQUIREMENTS