Good Way HPW-2600G, Инструкция по эксплуатации и техническому обслуживанию

Страница: 4 / 12

OPERATING INSTRUCTIONS
STARTING THE PRESSURE WASHER
Make sure that the burner switch is “OFF”
Connect water supply to the Washer. Turn on the water. Pull the trigger to allow water to run through the unit
expelling all air.
CAUTION
NEVER RUN THE WASHER WITHOUT WATER TURNED ON.
PUMP DAMAGE WILL OCCUR.
STARTING THE ENGINE
Ensure the engine tank is full of gasoline.
Hold securely and open the Trigger gun to reduce the load on the engine
CAUTION
THE FORCE OF THE WATER LEAVING THE NOZZLE CAUSES
A “KICK-BACK” OR RECOIL AT THE TRIGGER GUN.
Turn the Engine Switch on.
Adjust the choke if necessary
Pull the rope to start engine
Advance the throttle to bring the engine to full speed. Turn off choke
BURNER START UP
Turn Burner Switch to “ON”
The burner will start. Adjust the thermostat to obtain desired water temperature.
(SEE NEXT PAGE FOR DETAILED BURNER START UP INSTRUCTIONS)
CAUTION
DO NOT RUN THE FUEL PUMP DRY. ALWAYS CHECK THE FUEL LEVEL IN THE
TANK BEFORE RUNNING THE WASHER
CHANGING PRESSURE
The variable Unloader Valve is already set to full pressure. Do not adjust the Unloader past the maximum
pressure, as this will not increase the performance, and the excessive shut-off pressure will damage the
Washer.
CLEANING CHEMICALS
These pressure washers have a chemical injector. To use, put a liquid cleaner (such as APC-100 available
form Goodway) into the supplied soap container. Drop the pick-up hose with strainer into the container.
Replace the quick connect nozzle with the black low pressure nozzle. Soap will now be drawn into the water.
To stop chemical injection replace the low pressure nozzle with one of the three high pressure nozzles.
STOPPING THE WASHER
Turn off Burner Switch.
Pump cold water through the Washer for two minutes to flush out any remaining chemical (if used) and to cool
down all components.
Slow the engine to an idle and turn off the engine
4