2
ASSEMBLY INSTRUCTIONS
1
2
1. Using the provided Cardboard template
(II)
, mark locations
to install the Expansion Bolts
(AA).
Using a 1/2 in. masonry
bit (not included), Drill holes to a depth of 8.89cm/3.5in in the
marked locations. Hammer in the Expansion Bolts
(AA)
.
2. Remove the access door
(G)
from the lower base
(F)
by
unscrewing the 4 screws on the Access Door
(G)
. Mount the
upper base
(E)
onto the lower base
(F)
using the 4 provided
Hex screws
(GG)
and wrench
(HH).
IMPORTANT SAFETY INFORMATION
1.
DO NOT USE THIS FIXTURE IN A CIRCUIT HAVING A DIMMER CONTROL IN THE CIRCUIT.
2.
Do not
look directly at LEDs for extended period of time.
3. Install in accordance with national and local electrical codes.
4. Turn power off before servicing.
5. Do not leave bare wires exposed.
6. Use Minimum 90°C supply conductors. For additional electrical requirements, see fixture.
7. Do
NOT
install near other sources of light, which can fool the built-in light sensor into thinking it is daylight, and may
prevent the proper operation of the light.
8. LEDs can be damaged by electrostatic discharge shock. Before installation, discharge yourself by touching a grounded
bare metal surface to remove this hazard.
9. The LEDs in this product are non-Serviceable.
10.This fixture is controlled by a dusk-to-dawn photo light sensor. For the fixture to work properly, the wall switch controlling
the power to the fixture
MUST
be turned
ON
at
ALL
times.
11. This fixture is designed for use on a 110-120VAC, fused circuit.
12.
Light to be installed in accordance with this instruction manual or consult a qualified electrician for installation.
If unsure whether the electrical box is properly grounded, or the box is plastic and has no ground wire, or are unfamiliar with
the methods of properly grounding fixture, consult a qualified electrician.
Read entire installation procedure before you begin!
Shut off power at the circuit breaker or fuse panel before removing the old fixture and/or installing a new one.
AA
AA
AA
II
AA
F
G
GG
E
G
Note: This light needs to be mounted to a solid structure.
(Wood, concrete, masonry, etc..). the scope of these
instruction will focus on the mounting method used for a
concrete pad.
Tip: Screw on expansion bolt nut so that it is flat with
the surface of the bolt. This will provide a flat surface to
pound in the bolt with out damaging the bolt threads.
Screw Hole
