5
Receiving unit ► EX-57VAC-100E-A-RX
Front/Rear Panel
1.
Dip Switch:
for F/W update
2.
LED:
Power LED, Link LED, Signal LED
(1) Power LED: Power indicator LED
(2) Signal LED: When receiving unit receive the HDMI signal, the LED light will shine
(3) Link LED: Link indicator LED
3.
RCA connector:
local ARC output
4.
Latch-locking power jack:
Connect to 24V DC power supply
5.
RJ45:
Plug in a Cat-5/5e/6 cable that needs to be linked to the transmitting unit
EX-57VAC-100E-A-TX
6.
IR Receiver:
Infrared 3.5mm socket for plugging in the extension cable of IR receiver
7.
IR Blaster:
Infrared 3.5mm socket for plugging in the extension cable of IR blaster
8.
RS-232(terminal block format):
The order of RS-232 pin are TX, RX, GND (from the left side to the
right)
9.
HDMI OUT:
Connects to a HDMI display with HDMI male-male cable
10.
Ethernet port for LAN:
Connect to network device
DIP Switch Position
Description
PIN#1
OFF [
]
Reserved
ON [
]
Reserved
PIN#2
PIN#3
OFF [
]
OFF [
]
RS-232 normal use
OFF [
]
ON [
]
Reserved
ON [
]
OFF [
]
For system firmware update
ON [
]
ON [
]
For HDBaseT firmware update
6
IR PASS-THROUGH
IR Extenders
IR Blaster
IR Receiver
IR Sockets
IR BLASTER:
plug in the IR blaster to emit all IR command signals received from the IR receiver from the
other end to control the devices corresponding to the IR signals.
IR RECEIVER:
plug in the IR receiver to receive all IR command signals from the IR remote controls of
the corresponding devices.
Definition of IR Earphone Jack
IR Blaster
IR Receiver
You can buy any IR extension cables in the market that are compatible to the definition of
the IR sockets for the extender if necessary for replacement use. However, IR cables longer
than 2m (6-ft) may not work.
Incorrect placement of IR Blaster and Receiver may result in the failure of the IR extenders. Please check
carefully before plugging in the IR extender to the respective IR sockets. Warranty will not cover the damage.
CAUTION!
