FS 190
Operating instructions
- 14-
02821900988
5005967-04
In the cutting speed range all used blades must be designed for the max. rpm of the machine. Never
use faulty or damaged blades.
Danger: Faulty or damaged blades can cause injuries to the operator and other
persons!
When travelling on public roads, ways and places always observe the valid traffic regulations and, if
necessary, make sure beforehand that the machine is in a condition compatible with these regulations.
After operating secure the machine against unintentional moving.
Danger: The sound pressure may exceed 85 dB(A)!
Appropriate to the application of the machine it could be necessary to wear further protective
equipment.
Danger: Down coming parts at the building site can cause injuries to the operator!
5.3 Mounting the blade
Danger: Demolitioning parts can cause injuries to the operator while cutting!
Information: Wrong rotation of the blade will result in more wear of the blade!
Danger: Wrong rotation of the blade may result in segments cracking off and can
cause injuries to the operator or other persons!
Check the blade is well fastened before beginning to operate. Use only blades suitable to the blade
acceptance (arbor hole, flanges). Use only blade suitable to the material to be cut. Check the correct
water flow to the blade. If harmful or explosive stuffs like dust, milk-of-lime arise while cutting, observe
local regulations. Cut off the engine or disconnect the power supply before mounting or changing
blade. Check the correct rotation of the blade to the spindle shaft.
Cut off the engine before mounting the blade. Mount a blade with arbor hole of 25.4 mm - 1 in. and a
max. blade size of Ø 500 mm - 19.7 in. Check the correct rotation - arrows on the blade and blade
guard. Attach the blade guard.
5.4 Water supply
Danger: Do not use the attached water tank when cutting with wet cutting diamond
blades. The segments may crack off and cause injuries to the operator or bystanders!
Cutting with wet-cutting blades:
Connect the water supply to the GEKA-coupler of the machine. Check the ball valve is closed (ball
valve lever in 90°-position to the water flow). For cutting open the ball valve (ball valve lever in the
water flow position).
