41
onfiguration
switches
C
.
On installation with one monitor only, set it as master;
on installations with two monitors, set as master the monitor where the door
panel(s) is connected and the other monitor as slave.
Push button to stablish / finish audio communication or intercom function (only available
on systems with additional monitor, for description and connection see page 44 & 45).
Push button to activate the lock release. During call reception, communication and
autoswitch-on processes, it allows lock release activation. During activation, the picture
will disappear from the monitor screen.
:
(
).
Push button for a
It allows to establish audio and video communication with
the door paneI during 40 seconds. In case of systems with two door panels, press the
button again to monitor the picture from the second door panel.
Push button to activate the auxiliary device. D
, activate the auxiliary device (see page 46). During activation,
the picture will disappear from the monitor screen.
With system in rest ring tone selection monitor, for description see page
44
utoswitch-on.
uring call reception, communication and
autoswitch-on processes
unction push buttons.
F
Master
The configuration switches are placed on the monitor base.
On installations with two monitors, set as slave the monitor that is not connected
the door panel.
IMPORTANT: Modify the configuration switches
On installations with two monitors, set as master the monitor where the door
panel(s) is connected.
without the power connected.
all volume
control.
C
The monitor allows to regulate the call volume from maximum to
minimum value, with the regulator placed in the right side of the
monitor.
MONITOR DESCRIPTION
42
3
2
1
P2-
P2+
P1+
P1-
370S COLOR
M
S
-
+
+
Slave
MONITOR INSTALLATION
emove the bracket
installation.
R
Unscrew the monitor bottom screws.
Remove the bracket installation of the monitor.
ix the bracket installation to the
wall.
F
Avoid to place the monitor near to heating sources,
in dusty locations or smoky environments.
The bracket can be fixed using an electrical emmbeding
box or directly on the wall. To install directly over the
wall, drill two holes of 6mm. and use the supplied
screws.
The upper part of the bracket must be placed at 1,60m.
height roughly. The minimum distance between the
monitor and the closest object must be 5cm.
370S COLOR
M
S
370S COLOR
M
S
M
S
M
3
2
1
P2-
P2+
P1+
P1-
-
+
+
Nº serie 0903160000
*
*
Factory default.
