golmar Rock Series, Руководство по установке

Страница: 48 / 60

se of the end of line jumper.
U
The end of line jumper is located in CN2 connector, in the rear part of the
monitor. In systems with twisted pair, the end of line jumper is located in
the El562 module (see next paragraph)
Do not remove jumper in those monitors where the video cable end is
located.
Remove jumper only in intermediate monitors.
L562 module for video installations with twisted pair.
E
Find CN2 connector in the rear part of the monitor.
Before plug the EL562 module, remove the existing jumper and the
double one (JP1) that´s place on the right side.
NOTE: The doorpanel admits both installation types (coaxial or twisted
pair installation) without making any change.
See the specific installation diagram.
MONITOR DESCRIPTION
47 48
MONITOR INSTALLATION
escription of the RCPL-Uno connector
D
a
a
b
b
f
e
d
c
V /MP
in
HZ-
MALLA
A
D
REF
RCPL-UNO
LOTE
CODE
11784082
Colocar la parte superior de la regleta a 1,60m. del suelo.
Place the top part of the monitor connector at 1,60m. from the floor.
50mm.
50mm.
Presionar para abrir.
Press to open.
V /VP
o
a. Wall fixing holes (x4).
b. Monitor fixing pins (x2).
c. Cable vertical entrance. d. Fixing pin.
e. Cable central entrance.
f. Connection terminal block.
Put the monitor in a perpendicular position
to the connector, so that the holes on the
monitor base and the fixing pins of the
connector coincide, as shown in the
picture.
Close the monitor like a book, by pressing its
right side towards the fixing pins of the
connector until you hear a “click”.
If you need to remove the monitor after it has been
installed, press the fixing pin of the connector
by means of a flat screwdriver. Once the monitor
has been released, open it like a book and separate
it from the connector. Pay attention while
carrying out this operation: the monitor could fall.
osition the monitor.
P
Do not install the device near heat sources, in places with dust or fumes.
Install the monitor directly on the wall, by drilling four holes whose
diameter is 6mm and by using the screws and wallplugs supplied.
The upper part of the connector must be positioned
at a height of 1,60m from the ground.
The minimum distance between the connector sides
and any object must be 5 cm.
ix the monitor connector to the wall.
F