golmar 50124536, Инструкция по эксплуатации

Страница: 101 / 144

D OOR PANEL DESCRIPTION
D
. escription of the door panel
1xxx
2xxx
Grille module
600
C losing heads
3xxx
Push buttons module
C
E-6xx embedding boxes
Sound module
EL540
EL531 ,
, .
. on video systems with colour camera
on audio systems
, . on audio and video systems
, . on systems with more than eight push buttons
Push buttons encoder
EL516SE
Microprocessed circuit
EL500/R5
100
The Golmar video door entry system is a digital system, specially designed to replace
the 4+n or conventional electronic door entry systems in both apartment blocks and villas, making
use of the existing installation Adding to this, the fact that the system does not use coaxial cable for
video signal transmission (it is transmitted via an untwisted pair of wires), necessitates a detailed
study of the existing installation before installing the system To check that your installation complies
with the system's minimum recommended requirements, please read carefully the following chapters,
which provide details of the checks to be done
Vista PLUS
.
.
.
DEFINITION
99
Before installing this system, we must ensure that the existing installation complies with the following
requirements
All branch connections must be made using D4L-R5 or D4L-R5R distributors
Each floor must have physical space to situate the distributor/s and junction box in case of using
D4L-R5R distributors, in case they are necessary
Each apartment must have sufficient space to install the video system monitor
Maximum distance between the power supply and the farthest monitor
Maximum distance between the door panel and the farthest monitor
(according to
power supply's position)
Maximum number of terminals in total (monitors, telephones, call repeaters, etc.) (without
using converters)
Before connecting the system's power supply, we must ensure that there are
. If so, we must disconnect them or replace them
with units that are compatible with the new system, otherwise the installation could be seriously
damaged or burnt
If any of the first three requirements are not met, it will be necessary to replace the installation riser
If the branch connections to the apartments are in good condition, their replacement will not be
necessary
If replacing the backbone, use these sections
Golmar has a special cable for this system, its reference number is The use of this cable
ensures the correct functioning of the system and simplifies the riser replacement given that it contains
all the necessary wires for the installation
All the wires of the installation must use the same conduit, especially those that carry the
video signal and ground
The wires must not be spliced, frayed, nor touch metal parts, and must not vary in cross
section throughout the entire installation
The entire installation must be at least 40cm away from any other installation otherwise
there is a risk that the audio signal be exposed to interference, or that the system does
not work correctly
NO parallel units,
relays or call repeaters in the apartments
RAP-8415.
:
- .
-
.
- .
- : 50mts
- : 50/100mts
.
- : 200
-
.
.
:
.
-
.
-
.
-
.
MINIMUM REQUIREMENTS
1.00mm² 1.00mm² 2.5mm² 2.5mm²
0.25mm² 0.25mm²
Terminal
SECTIONS CHART
50m. 50m.
Power supply - Door panel Door panel - Monitors
100m. 100m.
V+, V-, A/D
+, , CV+, CV ~1 ~2
– –
, ,