Goldwing Corvus Racer 540 30CC, Руководство пользователя

Страница: 9 / 15

●
Drill a hole in the base of the rudder for the rudder steering guide
.
●
Before gluing with C
.
A
.
glue
,
place it over the thin rod
.
Aileron Servos
●
The ailerons on the wings are pre
-
glued
.
Check each one by gently pulling to make sure that they
are secure
●
Remove the covering where the aileron horns are glued in place. Use either a soldering iron or a
sharp knife
●
Using sand paper rough the area that will be glued into the aileron
.
●
Glue both horns in with epoxy glue ; use a bolt through the horns when gluing to make sure the
alignment is correct
.
●
Fit the aileron servo and drill fine holes where the servo screws will fit . Then apply thin to
strengthen the holes
.