Goldwing RC SBACH342 120E, Руководство пользователя

Страница: 10 / 49

Items required to complete this model:

26-38 cc gas engine with stock or aftermarket
exhaust system

Appropriate propeller for your engine

All the required engine and exhaust mounting
hardware

Ignition battery and switch

One quality throttle servo and appropriate
servo arm

3 high quality metal gear servos of 80 in-oz or
better for the ailerons and elevators

One high quality rudder servo of 160 in-oz or
better

Appropriate servo arms for the above

Servo wire extensions. Recommend KUZA
Twisted 22 AWG Servo Extensions (Not
included)
Two to three 12”(305mm) No. KAG002522
Two to three 18”(455mm) No. KAG002523

Switches with charging jacks for the Rx

Rx batteries of significant capacity to power
your choice of servos.

Receiver of your choice
Required tools

Covering Iron and heat gun

Assortment normal hobby tools such as
screwdrivers, hobby knife, drill and drill bits,
pliers, etc.

Thick and thin CA adhesives

30 minute epoxy

Isopropyl alcohol

Ruler or tape measure

Blue thread-lock or equivalent
Note: As with all kits, it’s a good idea to read all the instructions and study the parts before you begin
construction. Handle the parts of this kit with care so you do not damage any of the structure or covering.
Inspect all the parts for any shipping damage and report any issues to as soon as you can. Make sure you
have a flat and sturdy workbench and follow all safety advice for the tools and adhesives you plan to use.
AIRCRAFT COVERING
1. With all ARFs, varying temperatures and storage delays can cause covering material to loosen over time
and transportation. We recommend lightly going over all the covering with a covering iron set at medium
temperatures. Be sure to use a soft cover over your iron so you do not scratch the covering surface. Be
sure you go over all seams and edges of the covering to assure it is secure to the airframe and other
covering. Be careful not to apply too much heat or you may cause bubbles or damage to the covering. A
heat gun may also be used along with a soft cotton cloth to shrink and adhere the covering. Again, be
extremely careful when using a heat gun.
2. Be sure to seal any exposed wood with a thin coating of epoxy to prevent engine oil from soaking in. This
is especially important around the engine compartment and servo openings with exposed areas.
3. Some modelers prefer to seal the hinge gaps using strips of appropriate covering or clear trim tape. We
have found this to be helpful with models intended for higher speed flight or models with unusually large
hinge gaps. Our aircraft utilize a very tight double beveled hinge line and do not normally require this step.
Sealing the hinge gaps is therefore left as an option for the modeler.