7
5. Orient the Bench Frame (8) so that the hexagonal
holes are on the bottom. Attach the Bench Frame
to the Crossbar (5) with two M8 x 55mm Bolts
(64), two M8 Washers (50), and two M8 Nylon
Locknuts (49); and an M8 x 70mm Bolt (33) and
an M8 Nylon Locknut (49). Do not tighten the
Locknuts yet.
6. Slide the Seat Carriage (42) onto the Bench
Frame (8).
Attach the Front Leg (12) to the Bench Frame (8)
with two M8 x 52mm Bolts (59), two M8 x 58mm
Bolts (46), six M8 Washers (50), and four M8
Nylon Locknuts (49). Do not tighten the
Locknuts yet.
7. Set the pins on the Adjustment Tube (9) down
into a set of brackets on the Upright Bases (3, 4).
Tighten the M10 Nylon Locknuts (58) used in
steps 1–4, and the M8 Nylon Locknuts (49)
used in steps 5–6.
5
6
7
Pin
Pin
3
49
49
50
50
5
8
Hexagon
Holes
64
64
33
42
8
4
9
49
12 45
59
46
49
50
50
50
50
