9
•
Arrange the two transparent feet to be aligned with the back corners of the
speaker.
•
When the Epilogue 1 is in position, attach the two lateral arms of the frame to its
sides using the long Steel screws, the golden nuts, 2 teflon ring and the cylindrical
"molette". Please check the above schematics.
6. SPEAKERS PHYSICAL ALIGNMENT
To arrive to the listener simultaneously, the waves front created by each speaker
section have to be aligned to be at an equal distance from the listener position. This
is more critical in Stereo use than in multi-channel where the levels and delay of each
speaker are adjusted separately.
The departure position is when the rear part of each speaker's grill is vertically
aligned.
The Epilogue frame has been designed to allow the displacement of each speaker
section separately. The exact alignment may be obtained by measurements
However, a simple rule shows that for a listener seating at 3m5 (12') from the
speakers and with the hear level at the lower Epilogue 1 level, the displacement
needed are as follows, the Epilogue 3/4 being used as a reference :
•
The lower satellite must be pushed back by 25mm (1").
•
The Epilogue is aligned with Epilogue 3/4
•
The upper satellite must be advanced by 50mm from the Epilogue 2.
For a seating position at 6m (20'), the displacements would be :
•
The lower satellite must be pushed back by 12mm (1/2").
•
The Epilogue is aligned with Epilogue 3/4.
•
The upper satellite must be advanced by 28mm (1¼") from the Epilogue 2.
7. SPEAKER CONNECTIONS
Used in any type of configuration, the Epilogue 3/4 has a built-in amplifier and a built-
in input crossover.
The Epilogue 4 allows the input signal to be digital and provides two additional
switches to select the analogue or digital inputs and which channel of the SPDIF
signal is used.
