10
The only connections needed are the Power cord and the interconnect linking the
Epilogue 3 to the output of the preamplifier, or if you use the Epilogue 4 in digital, use
a digital link cable for input.
The Epilogue 3/4 may receive two analogue cables if one only one Epilogue 3/4 is
used so the right and left channels may be mixed automatically inside the crossover.
ATTENTION : If you use 2 x Epilogue ¾ in analogue, you have only one cable
that can be connected to any of the two available RCA inputs. In such a case,
always leave the unused input on each Epilogue 3/4 with a short-circuiting plug
mounted
.
ATTENTION : In most configurations, the ground wire from AC plug must
absolutely be lifted on all amplifiers and on the Epilogue 3/4 connection to the
AC line. Otherwise a bad ground loop may make amplifiers oscillate and be
destroyed.
The Epilogue 3/4 is automatically powered ON when it receives modulation.
For the Epilogue Full System connection, several possibilities are accessible.
The connection is different if the speakers are used in a multi-channel system or in a
2 channels system :
A. Connection in a Multi-Channel system :
If used in a multi-channel system :
•
The 2 x Epilogue 3/4 are connected in parallel to the sub-woofer channel.
•
The lower Epilogue 1 Satellites are connected in mono (parallel) to the center
channel.
•
The Epilogue 2 and upper Epilogue 1 satellite are the main right and left
channels. These two speakers may be connected to their respective or common
amplifier in three different ways as described below :
