5
Aqua Pod Operation
The Aqua Pod will control and program the Aqua Logic in the same manner as the
local keypad/display. Complete instructions on how to program and view/change
settings are available in the Aqua Logic Installation and Operation manuals. Use the
Aqua Pod's programming buttons for these commands.
Two menus shown below are available for the Aqua Pod that are not shown in the
Aqua Logic menus. These menus are directly accessible by repeatedly pushing the
Aqua Pod's MENU button. Refer to these menus and the information on page 6 to
map and operate softkeys.
Select softkeys
<previous next>
Scrolls through available Softkey Sets
Press repeatedly until “Select Softkeys” menu is displayed
Select Softkey Set
Use the "<" and ">" keys to scroll through all Softkey Sets. A
Softkey Set is a group of three pieces of pool equipment that
can be controlled by the three softkey pushbuttons. The
Softkey Sets are displayed in the Softkeys portion of the Aqua
Pod's display. Each softkey pushbutton controls the equip-
ment that is displayed directly above it. You can define and
make changes to Softkey Sets in the "Map Softkeys" menu.
Map softkeys
locked
Map softkeys
unlocked
Press BOTH buttons SIMULTANEOUSLY for 5 seconds to unlock
Scrolls to previous/next selection
Press repeatedly until “Map Softkeys” menu is displayed
Toggles between all available pool equipment
Map Softkeys
Push the "<" and ">" for 5 seconds to unlock. After entering
this menu, one of the displayed softkeys will be flashing. The
flashing selection can be changed by pressing the "+" or "-"
keys. When the desired selection is displayed, press the "<"
or ">" keys to advance to the previous/next softkey. Create
all desired softkey sets using this procedure.
You can SAVE, CANCEL or RESET at any time within the Map Softkeys menu by
pressing the corresponding softkey pushbutton below.
SAVE - This selection will save all changes that have been made to the softkey sets
since entering the menu.
CANCEL - This selection will cancel all changes that have been made since entering
the Map Softkeys menu and revert back to the previously saved selections.
RESET - This selection will revert the Softkey Sets to the original factory settings. All
saved selections will be lost.
Mapping Softkeys
After entering the Map Softkeys menu, refer to the diagram below for mapping infor-
mation. After exiting the Map Softkeys menu, the Aqua Pod will return to normal
operation.
Operating Status
Because the Aqua Pod is battery operated, it displays various information about its
condition and the status of its batteries. Refer to the section below for an explanation
of these displays:
Shutting down to
save battery power
After one minute of no button presses, the Aqua Pod will briefly show this display
and go into "sleep" mode. This mode conserves the battery power while the remote
is not in use. While asleep, the display will be off. To "wake" the unit up, push any
button on the keypad.
Refreshing display
When the Aqua Pod "wakes", it will show this display while it collects status informa-
tion from the Aqua Logic control unit.
6
Softkey Set 1:
Softkey Set 2:
Pool
(PS)
Cleaner
(V3)
Yard Light
(L)
Fountain
(A1)
Heat Pump
(H)
Gazebo Light
(A2)
Press the corresponding button
to Save, Cancel or Reset while
mapping softkeys.
Softkey currently being mapped
(blinks).
Press the “+” and “-” buttons to scroll
through the available selections to map
the Softkey.
Press the “<” and “>”
buttons to move
to the previous/next Softkey set. Note
that the selection will blink while being
mapped.
