4
output connector is plugged into the wireless remote display/keypad. If none of
the displays are working, check that 120V power is being applied to the main
control and that the 3A fuse (violet) is not blown.
5.
Display backlight turns off after a period of time
The display backlight should always illuminate when you press any key on the
unit. If it turns off after a period of time, you can stop this by pressing the menu
key (possibly multiple times) until “Settings Menu” appears. Next press the “<”
or “>” key (possibly multiple times) until “Display Light” appears. At this point,
pressing either “+” or “-“ will allow you to select either “Always On” or “On for
60 sec.”. After you have selected the desired operation, press the “Menu”
button to lock in your setting. Note that this selection applies to this wireless
remote display/keypad only. Repeat the process of each display/keypad in the
system.
6.
Display backlight always on
The display backlight should always illuminate when you press any key on the
unit. If it remains on after 60 seconds have elapsed since the last button push,
you can stop this by pressing the menu key (possibly multiple times) until “Set-
tings Menu” appears. Next press the “<” or “>” key (possibly multiple times)
until “Display Light” appears. At this point, pressing either “+” or “-“ will allow
you select either “Always On” or “On for 60 sec.”. After you have selected the
desired operation, press the “Menu” button to lock in your setting. Note that this
selection applies to this display/keypad only. Repeat the process for each dis-
play/keypad in the system.
7.
The last keypress
was not received
This is usually a temporary problem caused by interference from other equip-
ment that is using the same radio frequency. Try pressing the button again. If
this doesn’t work, go to the Settings Menu/Wireless Channel on any other
Aqua Logic display/keypad and select another channel. Note that after you
change the channel you will have to “re-teach” every wireless remote device in
the system.
8.
The base receiver
is not responding
If this is the first time you are using your remote, or if you have just installed a
new base receiver, run the “Teach Wireless” procedure from any other Aqua
Logic display/keypad. Also,
the radio signal may be too weak—try pointing the
remote in the direction of the pool equipment or try moving closer to the pool
equipment. If that doesn’t work, then there may be other equipment that is using
the same frequency. Go to the Settings Menu/Wireless Channel on any other
Aqua Logic display/keypad and select another channel. Note that after you
change the channel you will have to “re-teach” every wireless remote device in
the system.
9.
Teach Wireless needs
to be run
This is caused by the remote not knowing the ID code of the base receiver. Run
the “Teach Wireless” procedure from any other Aqua Logic display/keypad.
