7
Surface Mount HAND CONTROL OPERATION
1. To bring the back of the chair to an upright position, press button (S1)
and hold until the back reaches the desired position. Then release the button.
2. To recline the back of the chair, press button (S2) and hold until the back
reaches the desired position. Then release the button.
3. To raise the foot rest, press button (S3) and hold until the foot rest reaches
the desired position. Then release the button.
4. To lower the foot rest, press button (S4) and hold until the footrest closes.
Then release the button.
S1
S2
S3
S4
WARNING
Flopping down into the chair will damage it and could cause
personal injury.
Note: The motors are set to shut off when they reach their fully extended or fully
retracted position if the selected button is not released. If you should go past
your desired position, select the button to bring you back to your desired position.
You can repeat the process as often as you like.
Should the chair not operate, check all electrical connections to the chair. Make sure
everything is plugged in properly and there is power to the outlet into which the chair is
plugged (see installation on page 6 for electrical connections).
WARNING
Should you ever encounter a problem with the operation
of your power recline chair, such as mechanical or electrical problems,
discontinue all use of the product upon discovery of the problem.
Contact the provider from whom you purchased your chair. They will be able
to resolve problems and take care of proper factory service if needed. You will
need to be prepared to answer some basic questions about your power recline
chair, such as model and serial number. The model and serial number are located
at the rear of the frame. Prior to calling your provider, check all the electrical
connections to the chair. Make sure everything is plugged in properly and there
is power to the outlet into which the chair is plugged (see installation on page 6
for electrical connections).
