Golden Motor Folding E-bike FEB-600, Руководство пользователя

Страница: 18 / 29

All rights reserved.Golden Motor Technology Co.Ltd 2012
14
Originality Originality Originality Originality
、
Innovation Innovation Innovation Innovation
、
Creation Creation Creation Creation
Folding
Folding Folding
Folding E-bike
E-bike E-bike
E-bike ((((FEB-600
FEB-600 FEB-600
FEB-600)))) User's
User's User's
User's Guide
Guide Guide
Guide
have approximately a 1/3 of the charge left. Best to recharge the battery soon. To prevent the battery from
deep discharge, the controller has a low voltage protection cut-off set at 30.0 V. You may reboot the battery if
it cuts off, however continued use of the battery by switching off and on will cause deep discharge and
permanently damage the battery.
6.9
6.9 6.9
6.9
Lighting system
Folding E-bike(FEB-600) features wide angle high performance LED front and rear lights.They are powered
by the main battery; electrical consumption is negligible, be safe, use them often.
6.10
6.10 6.10
6.10
Lock
When parking your bicycle, turning the key to the " " position and removing it will shut the system off
and lock the battery in place. Use a chain lock to further secure your bicycle when necessary. We also
recommend you insure your bike against theft.
6.11 6.11 6.11 6.11 Central support stand
This spring loaded stand supports your bike straight up. Use your feet to depress the stand downwards
and pull the bike backwards. Ensure the stand is firmly rested on the ground before leaving the bike. Do not sit
on the bike with the stand parked. The central support stand is made of aluminum alloy and meant to only
take the weight of the bicycle and not with the rider on it.
6.12
6.12
6.12 6.12 Motor phase Calibrating
The controller can work brushless motors with different phase angles other than defaulted 120
degree. Below are procedures to allow the controller to match the motor phases:
� Cut-off power to controller and motor
�
Grip and hold power brake lever, turn throttle to maximum speed position, press
and hold the cruise control button, turn on the power switch (using battery key)
�
Connect battery power to the system, release throttle, release brake lever, release cruise
control button.
�
Listen for two beep sounds, then turn the motor wheel forward and reverse once.