THERMOSTATIC CONTROL
1.
Rotate thermostat knob clockwise until you reach the maximum position.
2.
When the room reaches a temperature that is comfortable for you, slowly turn the knob anti-clockwise
until the heater just turns off (you will hear a click).
3.
The heater will now cycle on and off to maintain the comfort level you have set.
4.
Take note of this setting position for future use
TIMER
You must set the time prior to programming the Timer.
To do this; turn the outer dial of the timer in a clockwise direction until the time of the day (24-hour clock)
corresponds with the triangular marking. Example if it is 2pm (1400 hours) then set the triangular mark in line
with 14. One complete turn of the dial corresponds to 24 hours.
There are 96
“riders”,
positioned around the dial, each rider represents 15 minutes.
Where all the
“riders”
are pushed to the outside of the timer the heater will be ON continuously.
To set a specific time for example:
If you want the heater to be on from 6pm to 10pm, then set all the riders from 18 to 22 (1800 hours to 2200
hours) to the outside of the rim and all other riders to the inside of the timer. The unit will then turn on
automatically at 6pm and off again at 10pm.
Operating your Appliance
Riders pushed to
the outside rim to
turn ON
Indicates actual time
Содержание Select GSOC1111T
Страница 1: ......
Страница 2: ...This page is intentionally left blank ...
Страница 11: ...This page is intentionally left blank ...
Страница 12: ......