
Using your iron
Goldair
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE
SPRAYING
Press the spray button to spray water on your
garment, as often as required.
Note: When using the water spray function,
ensure that there is enough water in the water
tank.
Note: You may have to pump the spray button
several times at first use.
STEAM SHOT OR VERTICAL STEAM
IRONING
Press the shot of steam button to generate a
powerful burst of steam that can penetrate the
fabric and smooth the most difficult, tough
creases. Wait for a few seconds before pressing
again.
By pressing the burst of steam button at
intervals you can also iron vertically (i.e. curtains
and hanging garments).
Note: The burst of steam function can only be
used at high temperature. Stop using the Steam
Shot when the pilot light turns on as iron needs
to heat up again. Start ironing again only after
the pilot light has turned off.
DRY IRONING
For ironing without steam, follow the instructions
in the section “steam ironing”, however, the
steam control turning switch should be set to the
DRY position. (no steam).
HOW TO CLEAN & STORE YOUR IRON
After using, disconnect from power and tilt the
water filling hole downward over a sink to empty
the remaining water from the water tank.
Let the iron cool completely, then wipe flakes
and any other deposits on sole plate with a
damp cloth or non abrasive liquid cleaner.
Clean upper part of iron with damp cloth.
Always store the iron horizontally on a stable
surface with a cloth protecting the sole plate.
SELF CLEANING FUNCTION
The self-cleaning feature cleans inside the
soleplate, removing impurities. We recommend
using it regularly according to hardness of water
and frequency of use.
1.
Fill water tank to MAX position and set
temperature dial to MAX position.
2.
Connect to power supply, making sure
Steam button is in DRY position. Stand iron
up vertically.
3.
When power indicator light goes out, hold
iron over sink and press SELF CLEAN
button. Steam and boiling water will come
out of soleplate, flushing out impurities and
calcium flakes.
4.
Release button as soon as water in tank
has been used up
AUTO SHUT OFF FUNCTION
If the iron not used more than 30 seconds in
horizontal position or 8 minutes in vertical
position, it automatically turns off and the light
will flash.
As soon as you use the iron again, it will
automatically turn on and the light will stop
flashing.