
COMPONENTS
BEFORE FIRST USE
Ensure any labels, tags or stickers that may be attached to the body or soleplate of the
iron are removed.
It is normal for a small amount of smoke and odor to be produced the first time your iron
is used, this is due to the initial heating of the materials used to make the iron. When
using the steam function for the first time do not direct the steam toward your garments,
as there could be debris from the steam vents that may damage the garment.
FILLING WITH WATER
We recommend the use of distilled water.
Ensure that both the steam control turning switch and temperature control dial are set to
the minimum/low heat position when filling.
Fill your iron only with water, do not add fabric conditioners, starches or any other
solution as these will damage the steam mechanism.
Hold the iron upright so that the water-filling inlet is in a horizontal position.
Fill by directing water though the water filling inlet until the water reaches the “MAX”
mark indicated on the side of the iron. Never fill above this mark.
SETTING THE TEMPERATURE
Follow instructions detailed on the label of the garment you wish to iron. If there are no
instructions, use the indicative chart following. If the garment consists of various fabric
types, select the temperature relevant to the most delicate of the fabrics that make up
your garment.
(1). Spray release
(3) Steam dial
(5). Shot-steam button
(7). Supply cord
(9). Transparent water tank
(11). Maximum water level
(13). Water measure
(2). Filler door
(4). Spray button
(6). Auto shot off indication light
(8). Cord bushing
(10).Thermostat knob for temperature regulation
(12). Plate with steam vents