![background image](http://html1.mh-extra.com/html/goldair/ghl425w/ghl425w_operating-instructions-manual_2240350005.webp)
INSTALLATION INSTRUCTIONS
1.The unit may be mounted either between joists using the inbuilt clip fasteners or against a joist using
a screw through the flange plate. The approximate cut-out size of the unit is 295 x 295mm.
Please note
this is only an approximate measurement and any installation would require a measurement against
the physical product to ensure the best fit.
Mark the ceiling with a pencil showing the area of ceiling to
be cut.
IMPORTANT NOTE: Goldair takes no responsibility for those instances where the physical product is not
measured first before the hole is cut in the ceiling.
2.Before commencing cutting ensure that the area behind the intended location is clear of all cables,
pipes and joists. Once clear, cut out the section along the previously marked lines.
3.Remove the lamps from the housing by unscrewing them anticlockwise. Then remove the decorative
fascia from the housing by removing the spring clips that hold it in place.
4.Insert the unit into the hole being sure to pull the side springs inward so that the body can pass
through the hole without damaging the plaster. Ensure that the unit is held securely in place by clips. It
is essential that additional screws (not supplied) are used to aid holding the unit in the ceiling. Screw
holes are provided in the flange for this purpose. 2 strips of timber (one on each side) should be placed
behind the holes inside the ceiling to give the screws something to anchor to and to provide some
reinforcing. Do not secure the unit at this time.
5.Remove the unit from the ceiling and connect the wiring to the terminal block as per the wiring
diagram. This terminal block is on one corner of the back of the unit.
6.Insert the unit into the hole and secure as detailed in point 4 above.
7.Hold the fascia against the body of the appliance and the ceiling, then attach the securing spring clips
to hold the fascia in place.
8.Now screw in the 275W heat lamps provided into the lamp holder through the holes provided in the
fascia. The globes should be screwed in firmly to ensure a good electrical contact but
don’t
over tighten.
Fit the small centre light bulb in the same way ensuring that it is positioned centrally.
IMPORTANT NOTE: Over tightening of heat lamps or light bulbs may result in damages to the lamp
holders or lamps, take care when removing and replacing heat lamps/bulbs
.
HEAT/LIGHT/VENT INSTRUCTIONS