Gold Note VALORE 425 Lite, Руководство пользователя

Страница: 8 / 24

7
SET-UP INSTRUCTIONS
1 Please remove carefully all the protecting foam and
check the items listed are all supplied.
2 Place the turntable deck on a levelled surface, the best
is a wall shelf immune to footfall, then level the turntable.
3 Plug the tone arm cable pre installed to the amplifier
phono input.
4 Install the counterweight into the rear arm wand of the
arm adjusting the correct cartridge tracking weight with
the help of a precision scale (not supplied).
5 Install the turntable belt surrounding the hourglass
motor pulley and the platter outer perimeter.
6 Plug the Power Adapter cable to the S/Steel rounded
plug motor cover underneath the turntable plinth bottom
left side corner.
POSITIONING THE VALORE 425 LITE
Your VALORE turntable has been designed for home Hi-Fi
systems. It must be protected from direct sunshine rays
and humidity. Do not put it close to strong heating
sources, electrical and electronic motors, mobile phones
etc.
The levelling and positioning on a solid shelf, as explained
in the previous chapter, is fundamental to ensure the
best audio performances.
OPERATING THE 33
⅓
rpm & 45rpm CONTROL
The turntable is fully controlled by an electronic power
supply.
FIRST OPERATION TURNTABLE SPEED CONTROL ADJUSTMENT
The turntable is fully controlled by an electronic power
supply operating the Turntable 33
⅓
rpm & 45rpm.
• Inner Button Start and Stop the 33
⅓
rpm speed.
• Outer Button Start and Stop the 45rpm speed.
The turntable also features a fine speed adjust “Pitch
Control” allows a very fine adjust of the speed of the
turntable.
PITCH CONTROL MODE
To enter the PITCH CONTROL MODE press and hold for 4
seconds both 33
⅓
rpm and 45rpm buttons while the
turntable is spinning.
When the red LED light shuts down, the unit is ready for
the fine speed adjustment.
• PITCH –
press repeatedly the 33
⅓
rpm button until the correct
speed is reached.
The LED light flashes every time the button is pressed.
• PITCH +
press repeatedly the 45rpm button until the correct speed
is reached.
The LED light flashes every time the button is pressed.
See pag.14 for images.
The TURNTABLE SPEED CONTROL unit records
permanently in the turntable memory the speed adjusted
singularly for both 33
⅓
rpm and 45rpm even if the
unit is unplugged from the AC wall.