The Breeze
Model No. 3030-00-000
Page 14
gmpopcorn.com
Floss Band and Element
Disassembly and Removal of Floss Band
1.
Unplug the machine from the power source and allow floss head to cool completely.
2.
Remove all sugar from the head of the machine before disassembling. If needed,
carefully turn the machine on its side and shake the sugar out.
3.
Remove the four spinner cap retainer screws and spinner cap. In some cases, the
sugar has caused the cap and band to stick together. Applying gentle pressure with the
heel of the hand should free the parts for removal.
4.
Remove the nylon acorn nut, lock nut, and terminal guard.
5.
Remove the retaining screws which fasten the element lead wires to the terminals
(use a 1/4” (9.5mm) nut driver); then remove the band and element. (See next page
for reconnecting element leads.)
6.
If there is excessive sugar build-up, run hot water over band and element until the
sugar dissolves (be careful to keep element leads dry). When the sugar has been
removed, allow the band and element to air dry overnight.
Note:
For models with separate heat and motor switches, the best way to dry the floss
head after reassembly is to spin it dry for 10 minutes
WITHOUT
HEAT
(use
motor switch only).
Tubular
Element
View
Nylon
Acorn
Nut
Lock
Nut
Terminal
Guard
Floss
Band
and
Element
Element
Lead
Wire
and
Retaining
Screw
Reference next page for
reassembly instructions.
