Gold Medal ShaveMaster II 1005, Инструкция по эксплуатации

Страница: 8 / 13

ShaveMaster II
M
ODEL
#1005
6
ORDERING SPARE PARTS
1. Identify the desired part by checking it against the photos, illustrations, and/or the parts list.
2. When ordering, please include part number, part name, and quantity desired.
3. Please include your model name and machine serial number (located on the machine
nameplate) with your order.
4. Address all parts orders to:
Parts Department
Gold Medal Products Co.
10700 Medallion Drive
Cincinnati, Ohio 45241-4807
or, place orders at:
(513) 769-7676
Fax: (513) 769-8500
E-mail: goldme19@eos.net
TROUBLESHOOTING
PROBLEMS CAUSES SOLUTIONS
Main shaft fails to turn with main
power switch on.
Cord not properly plugged in.
Broken power cord. Plug cord into properly.
Replace power cord.
Motor drive belt broken. Replace worn belt.
Front shield is open. Close front shield and latch.
Ice block jumps out of clamp.
Blade is raised too high.
Lower blade with adjustment
knob.
Blade is higher near center
than outside of platter. Remove shaving platter and
readjust blade height evenly.
Spikes not firmly embedded in
the ice block.
Lower clamp down with force.
Turn ice block over to flat side.
Shaved ice is too fine.
Shaver blade is too low. Raise blade into ice with knob.
Tension adjustment of brake
is too weak. Turn the shaving pressure knob
clockwise.
Shaved ice is too coarse.
Shaver blade is too high. Lower blade from ice with knob.
Tension adjustment of brake
is too strong.
Turn the shaving pressure knob
counterclockwise.
Blade is dull. Replace or sharpen blade.
Very hard to raise and lower the main
drive shaft with the handwheel.
Brake tension is too tight.
Ease the tension by turning the
shaving pressure knob
counterclockwise.