ReadyPop
®
Jr.
Model No.: 2783-00-000 (010, 020, 030)
Page 13
gmpopcorn.com
7.
Rinse kettle interior with clean water and a clean cloth.
8.
Dump any water remaining into a bucket (do not spill any in the interior of machine),
then wipe the kettle interior clean with a clean dry cloth.
For an extra dirty kettle, the process may be repeated; or, after turning kettle heat OFF,
allow solution to sit in kettle overnight. The next morning, finish the cleaning steps.
9.
With unit OFF and unplugged, use a clean SLIGHTLY damp cloth (wring ANY EXCESS
water from cloth before use) and wipe the kettle lead cord clean.
DO NOT get moisture
into the kettle lead-in cord, severe damage will result.
10.
After kettle cleaning, check to be sure the crossbar fasteners on the kettle are securely
tightened.
Daily Unit Cleaning Instructions
1.
Turn machine OFF, unplug unit and allow it to cool before attempting to clean.
2.
Remove the old maid pan, coil assembly, and corn pans—take them to the sink to
clean with soap and water, then rinse and dry.
To remove coil and corn pans:
(refer to Coil and Corn Pan Removal in Installation section)
1.
Remove any remaining popcorn.
2.
Remove the 2 side corn pans.
3.
Slide coil assembly off motor shaft.
4.
Lift the bottom corn pan out of unit.
3.
As needed, use a vacuum under corn pan to remove any debris.
4.
Clean area above the corn pans using a clean, SLIGHTLY damp cloth to remove any
grease from glass and cabinet (cloth may be SLIGHTLY dampened with soap and
water, then wipe again with clean water to remove any remaining cleaner).
5.
Clean glass panels with glass cleaner. Gold Medal Watchdog Glass Cleaner (Item No.
2588) is recommended.
Ammonia cleaners will damage plastic doors/panels. Only use a non-ammonia cleaner,
such as Gold Medal Watchdog Glass Cleaner (Item No. 2588).
6.
Reinstall the clean and dry pans/accessories.
7.
Check the kettle lead cord, make sure it is fully plugged into the kettle receptacle and
the plug is fully twisted to lock it into place.
