16 oz. Econo-16
Models #2024, 2024ST
10
Agitator Set Collar Adjustment
The following instructions describe how to properly adjust set collars on an agitator assembly with a fixed
stir rod.
Agitator Assembly with a FIXED Stir Rod
Steps to Adjust Set Collars on Agitator with a Fixed Stir Rod
Agitator assembly is adjusted while fastened to the kettle (image shown for general reference only).
Step 1.
Turn machine OFF, unplug unit, and allow it to cool completely before attempting to
adjust the agitator height.
Step 2.
Loosen the set screw in the set collar above the crossbar and below the crossbar.
Step 3.
Place a 1/32” gauge (thickness of a dime) under the base of the agitator shaft to adjust
clearance between the kettle cook surface and the shaft; reference image shown. Once adjusted,
re-tighten the set screw in the set collar above the crossbar to secure shaft in place.
Step 4.
Adjust clearance between the bottom of
the crossbar and the lower set collar to 1/32”
(thickness of a dime); reference image shown.
Once adjusted, re-tighten set screw to secure in
place.
Step 5.
To check for proper adjustment, make
sure the stir rod is parallel to the kettle cook
surface (it should be close - but not touching).
Step 6.
Spin the agitator shaft by hand to ensure
it spins freely and is not dragging the bottom of
the kettle.
Agitator shown for general
image reference only (lids not
shown for clarity).
Step 4: Adjust clearance
to thickness of a dime.
Kettle Cook
Surface
Crossbar
Set Collar w/Set Screw
above Crossbar
Lower Set Collar
Agitator Shaft
Step 5: Adjust clearance to
thickness of a dime.
Stir Rod (welded to shaft)
