2
MAIN FEATURES
The detector has two distinct systems:
1. ALL METAL No-Motion Mode: In this setting, detected targets will
cause the detector to sound off for as long as the target is under the
searchcoil—motion is not required to detect a target. When
operating in the ALL METAL Mode, adjust GND BAL(GROUND
BALANCE) to ensure proper mineral elimination. It is required to
push GND TRAC several times after adjusting GND BAL. All
targets will be detected with a medium tone.
2. Motion DISC (DISCRIMINATION), NOTCH and AUTO NOTCH
Modes: Operates with three tone audio target identification. GND
TRAC does not apply in these modes. User can adjust DISC and
NOTCH to reject any trash item. Motion is now required to make a
detection. Items will be tuned out if coil is not in motion.
Note: Do not attempt to test unit by placing a coin or metal objects onto
a floor. Most floors contain metal which interfere with the detector’s
operation.
ASSEMBLY
Assembling your metal detector is easy and requires no special tools.
Just follow these steps:
1. Clockwise turn the stem’s locknut to loosen it.
2. Press and hold down the spring button at the back of the stem to
lengthen or shorten the stem. Then release the button. Make sure
the button is in proper hole.
Adjust the stem to a length that lets you maintain a comfortable
upright posture, with your arm relaxed at your side and the
searchcoil level to the ground about 1/2 to 2 inches (1~5cm) above
the ground.
3. Counter clockwise tighten the locknut.
