PAGER PROGRAMMING SOFTWARE
ALA28 Programming
7
ALA28
ALA28 Programming
Introduction
Preparing a Pager for Reading or Programming:
Establish a computer hardware configuration.
Run the programming software of ALA28.
A Power LED illuminates on the Programming Interface to indicate
proper contact. If the Power LED did not illuminate then you must check
the configuration and restart the programming software of ALA28.
Align the pager contact pin holes with the contact pins of the ALA28
Programmer.
Press down on the pager until it is tight in the fixture.
Turn the pager off or wait the pager until standby mode.
The pager is
now ready to read or program.
Starting the Programmer
The application can be launched from
Gold Apollo
ALA28 Pager Programmer. The following window appears
Input your password. If key in wrong password for 3 times, the system shuts
off automatically. If the password is correct, the following window appears
Содержание AL-A28
Страница 1: ... ...
Страница 4: ...PAGER PROGRAMMING SOFTWARE Getting Started 2 ALA28 ...
Страница 15: ...PAGER PROGRAMMING SOFTWARE ALA28 Programming 13 ALA28 ...
Страница 24: ...PAGER PROGRAMMING SOFTWARE ALA28 Programming 22 ALA28 Source Prompts ...