WG600S Industrial Basic Variable-Speed Peristaltic Pump
the
Communication Instruction manual
for the parameters and supported
commands.
1) When the power is off, wire the DB15 connector as shown on
and connect it to the DB15 port on the rear of the pump. External DC
power source is recommend to avoid electrical interference.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
12VDC
VCC_W
COM
B
A
Figure 21. RS485 MODBUS Wiring
2) Turn on the power switch. The LED display will be on.
3) Press
SPEED ADJUST
dial to change the mode to
Communication Mode.
4) Change
DIRECTION
switch position to desired rotating
direction.
5) Control pump with communication interface.
6) Change
DIRECTION
switch to the middle position to stop drive anytime.
6.8
Footswitch Control
1) Switch the power of the pump off. Wire the DB15 connector as shown
, and connect it to the DB15 port on the rear
of the pump.
l215
14
