WG600S Industrial Basic Variable-Speed Peristaltic Pump
5
6
CW_W
External input signal to control direction
7
8
COM
Ground of external power
9
AGND
Negative of analog signal input
10
+12V
Positive of in12V power source
11
GND
Ground of Internal power source
12
13
RS_W
External start/stop signal input terminal
14
15
6
Operation Instructions
6.1
Before Operation
1) Please check the packing slip to make sure nothing is wrong or
damaged in the package. If there is problem, please contact the
manufacturer or distributor.
2) Read through the instruction
.
3) There should be more than 200 mm space for the back of the pump
when it is running.
6.2
Power Connection
The voltage of the power supply should be marked on the sticker of the pump.
Please make sure to use the right power source for the pump. Please plug
the power cord into the IEC Power Connector on the rear of the pump and
plug the opposite end of the power cord into an electrical outlet. Flip the
power switch located on the rear of the pump.
6.3
Internal Control Mode
On this mode, use the keys on the front panel to operate the pump.
8
