www.GoHz.com
7
Chapter V. Operating Guide
Menu Selection
Turn on the input switch, press SET button enter into main menu user interface, the main menu is divided into
four options:
1) Parameter Set; 2) Operating Parameters; 3) Abnormal Display; 4) Program Settings.
Press up/down ▲▼ buttons to adjust the selection, press OK button to enter the option.
Parameter Setting Procedure
1. Enter into "Parameter Set
" user interface, press up/down ▲▼ buttons to select the parameter sets (M0-M9),
press left/right
buttons
to change the underline position, press up/down ▲▼buttons to set the values.
2. Enter into "Operating Parameters" user interface, press up/down ▲▼ buttons to adjust the voltage value,
left/right
buttons
to adjust the frequency value. Note: the frequency converter output must in turn-on state,
otherwise the values can not be adjusted.
3. W/PF, switch power and power factor, the frequency converter default display is power.
4. Abnormal Display, display the frequency converter operating abnormality.
5. Program Settings, press up/down ▲▼buttons to switch terminate-parameter-sets, elect-parameter-sets and
running mode, press left/right
buttons
to change the sub-options of terminate-parameter-sets,
elect-parameter-sets and running mode. (The default running mode is "CYCLE", without special requirements,
please do not change it to "SEQUENCE".) Power output is only used for displaying whether the frequency
converter has output or not.
Specific Operation Settings
1. The frequency converter displays "Parameter Set" user interface after its power on.
2. Select the parameter sets (M0-M9).
(1) M1, M2, M3, M4 are the shortcut sets, press
to set the values, each set can be selected on
the operator interface directly.
(2) M0, M5, M6, M7, M8, M9 parameter sets are programmable for connecting computer operation.
(3) After parameters finalized, connect loads and press ON/OFF button, then the operator interface will
display frequency, current and power.
(4) Press up/down ▲▼buttons to set voltage, left/right
buttons
to set frequency online (with loads).
3. To change the operating voltage, press ON/OFF button to cut output, select the preset parameters stored in
M1-M4 and press ON/OFF to enable output.
