Godrej Appliances eyetrace elite ET-4D12E, Руководство пользователя

Страница: 19 / 42

19
function] > [Recording setup] to set.
Note:
There is at least one read-write hard disk.(refer to chapter 4.5.1)
Picture 4.1 recording setup
[
Channel
] Choose the corresponding channel number to set the channel. Choose the 'All' option to set the entire channels.
[
Redundancy
] Choose the redundancy function option to implement the file double backup function. Double backup is writing the video files in two hard disks. When you do
the double backup, make sure there are two hard disks installed. One is read-write disk and the other is redundant disk. (refer to 4.5.1)
[
Length
] Set the time length of each video file. (60 minutes default value)
[
Pre-Record
] Record 30 seconds before the action. (time length is decided by the code stream)
[
Mode
] Set video state: schedule, manual or stop.
·
Schedule
: Record according to the set video type (regular, detection and alarm) and time section.
·
Manual
: Click the button and the corresponding channel starts recording, no matter the channel in any state.
·
Stop:
Click the stop button and the corresponding channel stops recording, no matter the channel in any state.
[
Time section
] Set the time section of common recording. The recording will start only in the set range.
[
Recording type]
Set recording type: regular, detection or alarm.
·
Regular:
Perform the regular recording in the set time section. The video file type is “R”.
·
Detection:
Trigger the “motion detect”, “camera mask” or “video loss” signal. When above alarm is set as opening recording, the “detection recording” state is
on. The video file type is “M”.
·
Alarm:
Trigger the external alarm signal in the set time section. W hen above ala rm is set as opening recording the “detection record ing” state is on.
The video file typ e is “A”.
Note: Refer to chapter 4.3 to set corresponding alarm f unction.
4.2.2 Video playback
Refer to chapter 3.5.2.