- 31 -
- 32 -
AD600Pro can only be set as slave unit (receiver end). Press Wireless Selection Button to switch the two wireless
modes: built-in wireless transmission and external wireless transmission.
Wireless Flash Mode
Battery
Features
1.
This flash unit uses Li-ion polymer battery which has long runtime. The available charge-and-discharge times are
over 300.
2.
It is reliably safe. The inner circuit is against overcharge, overdischarge, overcurrent, and short circuit.
3.
Take only 2 hours to fully charge the battery by using the standard battery charger.
Cautions
Do not short circuit.
Do not expose to rain or immerse into water. This battery is not water proof.
Keep out of reach of children.
No over 24 hours' continuous charging.
Store in dry, cool, ventilated places.
Do not put aside or into fire.
Dead batteries should be disposed according to local regulations.
Please charge the battery to approx. 60% before being placed for long time.
If the battery had ceased using for over 3 months, please make a full recharge.
Loading and Unloading the Battery Pack
Push down the battery pack
2
until it is locked.
Match the battery's groove with
1
the main battery compartment's
ridge.
Push the battery pack upward
2
to unload it.
Push the Battery Locking Ring
1
to the right.
Loading:
Unloading:
Battery
Power Management
Long press the <ON/OFF> Power Switch for 1 seconds to control the on/off of the flash unit. Turn off the power
pack if the flash unit will not be used for an extended period. This product has auto power off function. The flash will
auto power off in 30 to 120 min. which is set on C.Fn-STANDBY.
Battery Level Indication
Attach the battery pack to the flash correctly. Be aware of the battery level by check the battery level indication on
the LCD panel when using.
Note: The indications are almost the same except of grids shift.
3 grids
2 grids
1 grid
Blank grid
Low battery and
charging reminder
1 red grid +3 green grids
1 red grid +2 green grids
1 red grid +1 green grid
1 red grid
2%: red light blinks
1%: the indicator is off.
75%~100%
50%~75%
25%~50%
3%~25%
Battery Level Indication
on the LCD Panel
(Indicating battery level and
management of the whole flash
system)
LED Battery Level Indication on
the Battery
(Indicating battery level and
management of non-loaded battery)
<2%
The battery level is going to be used out immediately.
And the flash will alarm for the 1 minute and auto power
off in 3 minutes. Note: Please recharge the battery as
soon as possible (within 10 days). Then, the battery can
be used or be placed for long period.
Meaning
/
Percentage of Battery Level
