C.Fn
Attaching to a Camera
Attach the Camera Flash.
1
●
Slip the camera flash’s
mounting foot into the
camera’s hotshoe all the
way.
Secure the Camera Flash.
2
●
Rotate the lock ring on the
mounting foot until it locks
up.
Detach the Camera Flash.
3
●
Rotate the lock ring on the
mounting foot until it is
loosened.
Power Management
Use Power Switch to power the flash unit on
(
Long press the
button for one second) or off. Turn off if it will not be used for an
extended period of time. Setting as a master flash, it will turn the
power off automatically after a certain period (approx. 90 seconds)
of idle use. Pressing the camera shutter halfway or pressing any
flash button will wake up the flash unit. Setting as a slave flash, it
will enter sleep mode after a certain period (adjustable, 60 minutes
by default) of idle use. Pressing any flash button will wake it up.
Disabling Auto Power Off function is recommended
when the flash is used off camera. (C.Fn-ST, Page 47)
Flash Mode: TTL Autoflash
This flash has three flash modes: TTL, Manual (M), and Multi
(Stroboscopic). In TTL mode, the camera and the flash will work
together to calculate the correct exposure for the subject and the
background. In this mode, multiple TTL functions are available:
FEC, HSS, second curtain sync, etc.
*
Press <
MODE
> Mode Selection Button and three flash modes will
display on the LCD panel one by one with each pressing.
TTL Mode
Press <
MODE
> Mode Selection Button to enter TTL mode. The
LCD panel will display
<
TTL
>.
●
Press the camera release button halfway to focus.
●
When the shutter button is fully pressed, the flash will fire a pre-
flash that the camera will use to calculate exposure and flash
output the instant before the photo is taken.
Display“
HI
”: When the flash output value is up to the maximum
value, “HI”will be displayed and blinking for 3 seconds. Adjust
the camera’s parameters if underexposure appears.
Display“
Lo
”: When the flash output value is up to the minimum
value, “Lo”will be displayed and blinking for 3 seconds. Adjust the
camera’s parameters if overexposure appears.
- 35 -
- 36 -
FEC: Flash Exposure Compensation
With FEC function, this flash can adjust from -3 to +3 in 1/3rd stops.
It is useful in situations where minor adjusting of the TTL system is
needed based on the environment.
Setting FEC:
Turn the Select Dial to set the
2
amount.
●
“0.3”means 1/3 step,
“0.7”means 2/3 step.
●
To cancel the flash
exposure compensation,
set the amount to “+0”.
Press <
SET
> button again
3
to confirm the setting.
Press the
SET
Button and
1
the flash exposure
compensation amount will be
highlighted on the LCD panel.
SET
MODE
ZOOM
SYNC
SLAVE
SET
MODE
ZOOM
SYNC
SLAVE
SET
