Godox TT685II-O, Руководство пользователя

Страница: 24 / 174

24
Multi: Wireless Flash Shooting with Manual Flash
1. Setting <MULTI> Stroboscopic flash
•
Press <MODE> button so that <MULTI> is displayed.
• Setting the stroboscopic flash.
The Reason & Solution of Not Triggering in Godox 2.4G Wireless
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless base
station, 2.4G wifi router, Bluetooth, etc.)
•
To adjust the channel CH setting on the flash trigger (add 10+ channels) and use
the channel which is not disturbed. Or turn off the other 2.4G equipment in
working.
2. Please make sure that whether the flash has finished its recycle or caught
up with the continuous shooting speed or not (the flash ready indicator is
lighten) and the flash is not under the state of over-heat protection or other
abnormal situation.
• Please downgrade the flash power output. If the flash is in TTL mode, please try
to change it to M mode (a preflash is needed in TTL mode).
3. Whether the distance between the flash trigger and the flash is too close or
not (<0.5m)
• Please turn on the “close distance wireless mode” on the flash trigger
•
X2 & X1 series: press the test button and hold on, then turning it on until the flash
ready indicator blinks for 2 times.
•
XPro series: Set the C.Fn-DIST to 0-30m.
4. Whether the flash trigger and the receiver end equipment are in the low
battery states or not.
•
Please replace the battery (the flash trigger is recommended to use 1.5V
disposable alkaline battery).