- 22 -
Setting <Multi>
1
stroboscopic flash.
●
Long press the <
MODE
>
button for 2 seconds so that
<
Multi
> is displayed. Long
press the <
MODE
> button
for 2 seconds again to exit.
7. M: Wireless Flash Shooting with Manual Flash
This describes wireless (multiple shooting) using manual flash. You
can shoot with a different flash output setting for each slave unit
(firing group). Set all parameters on the master unit.
Setting the flash mode to
1
<M>
●
Press the <
MODE
> Button
to set the flash to M mode.
Setting flash output
2
●
Turn the Select Dial to set
the flash output of the
groups.
Taking the picture
3
●
Each group fires at the set
flash ratio.
Using a flash (master/slave) with a radio transmission wireless
shooting function make it easy to shoot with advanced wireless
multiple flash lighting, in the same way as TTL autoflash shooting.
The basic relative position and operation range are as shown in the
picture. You can then perform wireless TTL autoflash shooting just
by setting the master unit to <
TTL
>.
8. Multi: Wireless Flash Shooting with Manual
Flash
Setting flash output/flash
2
frequency/flash times.
●
Setting the flash
output/flash frequency/flash
times in the M group. Setting
the multi flash mode. (see
Page35 )
●
A, B and C group can only
control the ON/OFF of the
slave unit by pressing the
<
MODE
> Button.
Transmission distance is about 30m.
● Use the supplied mini stand to position the slave unit.
● Before shooting, perform a test flash and test shooting.
● The transmission distance might be shorter depending on
the conditions such as positioning of slave units, the
surrounding environment and whether conditions.
You can divide the slave units into two or three groups and perform
TTL autoflash while changing the flash ratio (factor). In addition, you
can set and shoot with a different flash mode for each firing group,
for up to 3 groups.
Wireless Multiple Flash Shooting
●
Auto Shooting with Two Slave Groups
Slave/Master Unit's Positioning and Operation Range
●
Autoflash Shooting with One Slave Unit
A
B
A
B
C
●
Auto Shooting with Three Slave Groups
- 39 -
- 40 -
MODE
ZOOM
SYNC
SLAVE
SET
MODE
ZOOM
SYNC
SLAVE
SET
MODE
ZOOM
SYNC
SLAVE
SET
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless base
station, 2.4G wifi router, Bluetooth, etc.)
→
To adjust the channel CH setting on the flash trigger (add 10+ channels) and
use the channel which is not disturbed. Or turn off the other 2.4G equipment
in working.
2. Please make sure that whether the flash has finished its recycle or
caught up with the continuous shooting speed or not(the flash ready
indicator is lighten) and the flash is not under the state of over-heat
protection or other abnormal situation.
→
Please downgrade the flash power output. If the flash is in TTL mode, please
try to change it to M mode(a preflash is needed in TTL mode).
The Reason & Solution of Not Triggering in Godox 2.4G Wireless
