Buzz Function
The sound button (8) is used for deciding whether there is sound reminder for
ready flash after recharging. When the buzz indicator is on the LCD panel, the
buzz function is working; when it is disappear, the buzz function is not working. A
“BI” sound will be heard when it’s fully charged.
Key Combination
Synchronously press the GR/CH button and the S1/S2 button can turn on/off the
built-in wireless transmission. If there are no wireless and channel indicators
displayed on the LCD panel, the built-in wireless transmission is off. On the
contrary, the built-in wireless transmission is on. Synchronously press the S1/S2
button and BUZZ button to recover factory settings.
Alarm Display
E0 The temperature sensor is not connected.
E1 When charging, the capacitance and voltage are not rising within 1 second.
E2 The fastest heating-up component is over the extra temperature.
E3 Discharged capacitance and voltage
10%
＞
Alarm sounds, BIBI, ringing per 0.5 second. Press SET button to stop alarming.
Memory Function
The device is equipped with memory function for the panel setting. It will help
remember the panel setting 3 seconds after you set it. When starting up the flash
next time, the panel setting will be the same as that before powering it off.
Wireless Control Function
The flash unit has built-in 2.4G wireless transmission, which can be used
together with X1 and XT16 flash trigger.
Synchronously press the <GR/CH> Button and the <S1/S2> Button can turn on
the built-in wireless transmission and the < > is displayed. If there are other
wireless flash systems nearby, you can change the channel IDs to prevent signal
interference. The channel IDs of the master unit and the slave unit(s) must be set
to the same.
CH
S
OFF
ON
CH
S
OFF
ON
Long press the <
GR/CH
>
1
Button for 2 seconds until
the channel IDs is blinking.
Turn the Select Dial to choose
2
the channel from
1
to
32
.
Press the <
SET
> Button to
3
confirm.
CH
S
OFF
ON
CH
S
OFF
ON
CH
S
OFF
ON
CH
S
OFF
ON
Short press the <
GR/CH
>
1
Button for 2 seconds until
the group IDs is blinking.
Turn the Select Dial to choose
2
the group from
0
to
F
.
Press the <
SET
> Button to
3
confirm.
Setting the Communication Channel
Setting the Communication Group
The flash unit is built in with a Wireless Control Port so that you can
wirelessly adjust the power level of the flash and the flash triggering.
To control the flash wirelessly, you need a FT-16 remote control set (on-
camera and on-flash). Insert its receive end into the Wireless Control
Port on the flash and insert the transmit end into the
camera hot shoe. Settings made on the hotshoe-
mounted transmit and receive ends will be wirelessly
communicated to the flash. Then you can press the
camera shutter release button to trigger the flash. You
can also hold the transmit end at hand to control your
off-camera flash.
For full instructions on the use of FT series remote control, see its user
manual.
- 15 -
- 16 -