When there is flammable accessory on the flash unit, do not keep the
modeling lamp on for a long time. It is recommended to cool it down
for one minute after 10 minutes' working.
Power Output Control
Test Button
Sync Triggering
Slave Trigger Model
◆
◆
◆
Buzz Function
Flash output controller (5) decides different power output, satisfying light
requirements in different environment. The power is adjustable freely from 5.0 to
8.0 which will be accordingly shown on the digital display (10). "OF" on the
display indicates that the flash triggering function is turned off. It can
automatically discharge power when the flash output is adjusted from high to low.
To fire the flash without taking a picture, press the test button (9). It can also help
adjust the flash brightness when combined with the flash output controller (5).
The sync cord jack (2) is a Φ 6.35mm
plug. Insert a trigger plug here and
the flash will be fired synchronously
with the camera shutter.
Three slave triggering models are
available and can be set by pressing Slave Model Button (8).
No optical control: The slave triggering indicator (13) is off, indicating the slave
triggering function is shut down.
One fire model: The slave triggering indicator (13) glows blue, indicating the
flash will fire synchronously when receiving one external flash. In this model, the
flash can function as an auxiliary lamp, offering various effects of light and
shadow.
Anti-preflash model: The slave triggering indicator (13) glows red, indicating the
flash will receive two external flashes within 2 seconds and will fire synchronously
when receiving the second flash. In this model, the flash can function as an
auxiliary lamp, applicable to TTL system. With this anti-preflash function, the flash
can synchronize with cameras having a one-preflash firing system.
The sound button (7) is used for deciding whether there is sound reminder for
ready flash after recharging. When the buzz indicator (12) is on, the buzz function
is working; when it is off, the buzz function is not working. A “BI” sound will be
heard when it’s fully charged.
Memory Function
Wireless Control Function
◆
◆
◆
Tube Replacement
The device is equipped with memory function for the panel setting. It will help
remember the panel setting 3 seconds after you set it. When starting up the flash
next time, the panel setting will be the same as that before powering it off.
The flash unit is built in with a Wireless Control Port (17) so that you can
wirelessly control the on-and-off of your flash, modeling lamp and buzzer, as well
as adjust the flash output level, etc.
To control the flash wirelessly, you need a Godox FT series remote control set
(on-camera and on-flash). Insert its receive end into the Wireless Control Port
(17) on the flash and insert the transmit end into the camera hot shoe. Settings
made on the hotshoe-mounted transmit and receive ends will be wirelessly
communicated to the flash. Then you can press the camera shutter-release
button to trigger the flash.
For full instructions on the use of FT series remote control, see its user manual.
Shut down the power and remove the power cord before replacing the flash tube.
Wear insulated gloves to loosen the iron wire on the tube, keep a balanced hold
on the two feet of the flash tube and pull out the old tube gently. Take down the
feet casing from the old tube and put it on the new one. Hold two feet of the new
tube, and target directly towards the two copper outlets, then push them slightly
in. Twine the iron wire on the stainless steel sheet to fix the flash tube.
- 05 -
- 06 -
