10
9
（
1
）
Power Socket
（
2
）
Fuse
（
3
）
Power Switch
（
4
）
Test Button
（
5
）
Flash Output Controller
（
6
）
Light Sensor
（
7
）
Charging LED Indicator
（
8
）
Modeling Light Switch
（
9
）
Sync Cord Jack
（
10
）
Mounting Bracket
（
11
）
Umbrella Input
1
2
3
4
5 6 7
8
9
11
10
Instructions for Use
●
Power Connection
Use the power cord to connect the flash to an AC power source and turn
on the power switch (3). The charging indicator lamp (7) is off when it is
charging, no flash at this moment. The unit is ready to fire until the
charging indicator lamp (7) is on, meaning it is fully charged. Set the
power switch on O position when it is not in use.
●
Modeling lamp
Modeling lamp switch (8) decides whether the modeling lamp is on or
off: Downwards (O position), it’s off; upwards (I position), it’s on.
(NOTE: Do not keep long time in using the modeling lamp. It’s better
to be cooled down for 1 minute after 5 minutes continuous use.)
●
Flash Output Control
Flash output controller (5) controls the power radio, adjustable
stepless power from 1/8 to full. It can satisfy the light requirements in
different environment. (Note: When adjusting the power from full
power to a lower setting, press the test button to release the power in
the capacitor, so when recharged, the flash output will be in the
corresponding setting.)
●
Test Button
To fire the flash without taking a picture, push the test button. It can
also adjust the brightness when combined with the flash output
controller (5).
●
Sync Triggering
A sync cord (9) is provided with your flash unit, and the input is a Φ
3.5mm mini plug. Insert a trigger plug here and the flash will be fired
synchronously.
●
Flash Preparation
Mount the flash unit on an appropriate light
stand and adjust the mounting bracket (10).
Make sure it’s tightened and fixed. The
umbrella input (11) is applicable for any
studio umbrella.
Names of Parts
●
Accessories
●
Body
Modeling Lamp
Power Cord
Instruction Manual
