POÊLE À GAZ GODIN ref. 3428
12
TESTING THE APPLIANCE
IMPORTANT: Read instructions carefully before starting. Clearances to combustibles must be
observed. The stove must be properly assembled and installed. Installations other than those
specifically covered herein have not been confirmed by test. Be certain you have a chimney
that draws well, does not smoke or is not susceptible to down drafts. A stove will not perform
properly in any chimney that has draft problems.
Prior to installation the chimney should be cleaned. Be certain it is free of obstructions,
cracks, loose bricks or other deterioration. Consult with a professional fireplace mason if
repairs are necessary.
A coating of grease protects some internal parts against rust and an first lighting their heating
may release a little smell which is normal and transitory.
When the appliance has been suitably installed and connected to the smoke duct it should be
operated with a low fire for several hours.
When the appliance is lit which is connected to a cold chimney which has not been used for
some time, there may be difficulties with the draught. The conclusion should not be drawn
prematurely that the appliance or the smoke duct is defective but rather wait at least a day for
confirmation.
GAS JETS REPLACEMENT PROCEDURE
IMPORTANT :
Before any acting on your gas heating stove, make sure that gas arrival pipe is securely
closed.
Burner jet
1. Open the top of the stove and unscrew using a 10 mm tool
2. Remove the opening top and its basis being careful not to damage the enamel depending
the case.
3. You then have an easy access to the internal of the appliance where a metal air proof
component is fitted. Bring this component towards the front of the stove and remove from
the cast iron pipe. Remove the component out of the stove.
4. Open the front door of the stove for free access to the burner
5. On the burner’s left hand side, unscrew the part maintaining the burner on its support
Push this assembly to the left in order to remove it
6. Unscrew the jet from the burner using a 7 mm tool and replace it
Pilot jet :
1. Remove the lighting candle by pulling it from its fixing support. It will allow an easier
access.
2. Unscrew then the aluminum pipe leading to the pilot jet. The jet should so come easily,
help it if necessary.
3. Replace the pilot jet.
