POÊLE À GAZ GODIN ref. 3428
11
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above on this label.
2. Make sure the manual shutoff valve is fully open.
3. Push in gas control knob(A) slightly and turn to ‘’OFF’’ position. Do not force.
4. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If
you smell gas, STOP! Follow “WHAT TO DO IF YOU SMELL GAS” in “FOR YOUR
SAFETY READ… section. If you don’t smell gas, go to the next step.
5. Visually locate the pilot assembly by main burner. Starting from the “OFF” position, turn
the knob (A) counterclockwise
4
towards “IGNITION” position until a stop limit is
reached, and press it down. Wait five (5) seconds.
6. Turn the knob (A) further from the pressed position until it reaches the ‘’STAND-BY”
position. Wait ten (10) seconds after the pilot burner has been lit.
7. Release the knob (A) and it will pop up. Check that the pilot flame remains alight. If it
goes out, repeat steps 3 to 6.
•
If the knob does not pop up when released, stop and immediately call your service
technician or gas supplier.
•
If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” position
and call your service technician or gas supplier.
8. Turn the knob (A) to “ON” position. Finally turn the thermostat knob (B) to the set point (1
to 7) corresponding to the desired temperature.
TO TURN OFF GAS TO APPLIANCE
1. Turn
clockwise
3
the control knob (A) to the “STAND-BY” position.
2. Press the knob (A) slightly to get it out of the “STAND-BY” position slot and turn it to the
“OFF” position. Do not force.
3. After about one (1) minute (drop out time of thermocouple) the lighting procedure can be
repeated.
