Godin 362105, Инструкции по установке

Страница: 7 / 13

7 | P a g e
LIGHTING AND REGULATION

Use the unit on low fire for the first 2 – 3 days to allow the parts of the unit to expand naturally.

Use the operating tool or glove when opening the door.

Do not worry if during the first lighting fumes are emitted from the unit, this is due to oils used during
the manufacturing process and the curing of the paint. The smell of fumes will dissipate after the unit
has been used a few times.

To light the unit – open the door and insert smaller pieces of wood – light the unit – fill slowly and
moderately, while leaving the air intake completely open.

To assist with the initial lighting of the unit, it is possible to leave the door slightly open for a few
minutes.

Once the fire is well lit, load the necessary amount of wood and adjust the air intake accordingly.
REMOVAL OF ASHES

Remove the ash pan at least every 2-3 days or every 8 hours.

Never let the ashes build up in the ash pan until they touch the grate. This would stop the grate from
cooling down and would cause the grate to rapidly deteriorate.
SWEEPING OF THE CHIMNEY

It is advisable to sweep and inspect your chimney at least once a year. Clean the unit and check the
door seals. Inspect the internal flue and remove and clean the T-piece bowl if it has been utilized. Use
the Godin chimney cleaner Ref: 0008 at the beginning and end of each season. Clean the internal part
of the appliance thoroughly without forgetting the top of the baffle plates.

It is important never to attempt to clean the glass of the unit while it is still hot.
THE IMPORTANCE OF FUEL
Godin heaters have a thermal output close to 70% efficiency. Never the less, you must not forget that its
heating is only as efficient as the energy included in the materials used.
If the stoves heat performance is unsatisfactory to you, it could be one of two things:
- Either the fuel quantity is not enough or
- The fuel burnt has a low energy output
Only burn dry wood that has been dried for at least 2 -3 years. Humidity in the wood goes from 15% to 50%
(for wet wood). Normally all woods have the same calorific power for the same weight. Hard wood is more
suitable as it has a higher density and often has less humidity. Using wet wood can damage the chimney and
cause fires in the chimney flue.
REPLACEMENT OF PARTS
If you need to replace some parts, please contact your supplier or one of our approved dealers, give him the
product date as displayed in your warranty slip, or on your appliance’s name plate at the rear of the unit. Our
dealers are in possession of all spare parts and technical datas about our products, and will provide you with
the spare parts you need and any maintenance intervention within the scope of the professional competence.