Godex C-650Plus II, Руководство пользователя

Страница: 15 / 48

User Manual
10
The Operator Panel
The operator panel is located in the middle of the printer cover and is composed of function keys and leds
with which you can easily check the printer status and select the functions.
Function Keys
KEY NORMAL MODE SETUP MODE SPECIAL MODE
When using the IBM 4722, IBM 9068 and
the Olivetti protocols in two operators
(
“booking”) mode, the application software
determines the function of this key.
When the Printer is in
the Printer Setup mode,
pressing this key the
operator
selects the
Configuration Page to
be printed. See
“
Printer
Setup
” later in this
manual.
When pressed while
powering the printer on
with READY key selects
the
T&D mode
(diagnostic).
When
pressed while
powering the printer on
with cover open enters in
firmware
upgrading
procedure.
Toggles the printer between Ready (on-line)
and Local (off-line) status.
If pressed in the Printer
Setup mode, the printer
prints the Self Test Page.
See
“
Printer Setup
” later
in this manual.
When pressed while
powering the printer on,
selects the Printer Setup
Mode.
When
pressed while
powering the printer on
with ST1 key select the
T&D mode (diagnostic).
Pressing this key, when the printer is offline,
or when the printer is online and no print
data are in the buffer, the printer ejects the
paper, if inserted (EJECT function). In the
Olivetti protocols, the EJECT function may
be performed only if the printer is offline.
When using the IBM 4722, IBM 9068 and
the Olivetti protocols in two operators
(
“booking”) mode, the application software
determines the function of this key.
When the printer is offline or when the
printer is online and no print data are in the
buffer, pressing this key, the printer toggles
between Letter Quality and Draft printing mode
(no Olivetti)
When the Printer is in
the Printer Setup mode,
pressing this key the
Setup Page selected
with the ST1 key will be
printed. See
“
Printer
Setup
” later in this
manual.
When pressed while
powering the printer on,
selects the HEX_DUMP
mode.
See
“
Hexdump Mode
”
later in this manual.