6
Loading large-size label roll
1.
Power on.
2.
Press the two lock switches (part 6) and lift up a little to open the rear cover. (See figure
2.3.1)
3.
Remove the label roll stands. Vertically place the two stands along the left and right sides
of the rear cover.
4.
Place the large-size label roll on the stands (see figure 2.3.3).
5.
Insert the edge of labels into the label guide, until0l the edge is blocked by the printhead.
6.
Press feed button to drive the label (under the printhead) into the printer.
Fig. 2.3.3
2-4. Testing the BZB printer
The self-test function helps you check if the printer works normally.
To start the self-test function, please follow these steps.
1.
Load the label. (As described in 2-3)
2.
Power the printer OFF and wait for 2 seconds).
3.
Hold down the feed key and power the printer ON.
4.
Release the feed key and wait for few seconds. The printer will print a self-test page.
Note: To disable the self-test, please power OFF the printer at least 2 seconds,
then power ON again.
