Goddess DTC656MW8F, Инструкция по эксплуатации

Страница: 118 / 162

EN - 118
EN
Protect Against Freezing
If your dishwasher is left in an unheated place during the winter, ask a service technical to:
1. Cut off electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain water from t he inlet pipe and water valve. (Use a pan to catch the wat er)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter in the tub the bottom and use a sponge to use up water in sump.
Cleaning the Spray Arms
It is necessary to clean the spray arms
regularly for hard water chemicals will clog the
spray arm jets and bearings. To remove the
spray arms, grasp the middle of the spray arm,
pull it upwards and remove the arm. Wash the
arms in soapy and warm water and use a soft
brush to clean the jets. Replace them after
rinsing them thoroughly.
Cleaning the Filters
à
Inspect the filters for obstructions every time the dishwasher has been used.
à
By unscrewing the coarse filter.you can remove the filter system. Remove any food
remnants and clean the filters under running water.
step 1: Turn the filter in anti-clockwise direction.
step 2: lift the filter system up.
NOTE:
When following this procedure from step1 to step 2. the filter
system will be removed; when following it from step 2 to step
1, the filter system will be snstalled .
Filter assembly
à
For best performance and results, the filter assembly must be cleaned.
à
The filter efficiently removes food particles from the wash water, allowing it to be
recirculated during the cycle.
à
For this reason, it i s a good i dea to remove the l arger food particles trapped in the filter
after each wash cycle by rinsing the semicircular filter and cup under running water. To
remove the filter assembly, pull on the cup handle in the upward direction. The entire
filter assembly should be cleaned once a week.
à
To clean the coarse filter and the fine fi lter, use a cleaning brush. Then, reassemble the
filter parts as shown in the figures left and reinsert the entire assembly in the dishwasher,
positioning in its seat and pressing downward.