Goddess DFE1267DW9E, Инструкция по эксплуатации

Страница: 114 / 152

EN - 114
EN
Water Connection
WARNING!
In order to avoid that there is more water staying in the inlet hose, please
close the hydrant after using.(For the models: no safety inlet hose.)
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4 (inch)
connector and make sure that it is fastened tightly in place.
Water pressure 0.04 – 1.0 MPa. If the water pipes are new
or have not been used for an extended period of time, let
the water run to make sure t hat the water is clear and free of
impurities. If this precaution is not taken, there is a risk that the
water inlet can get blocked and damage the appliance.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind
it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with
water supply and drain hoses that can be positioned to the right or the left to facilitate
proper installation.
Levelling the Appliance
à
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust
the height of the dishwasher, making it level. In any case, the appliance should not be
inclined more than 2.
à
NOTE: The maximum adjustment height of the feet is 20 mm
Drain hose Connection
m
ax
110
0 m
m
m
in 5
00 m
m
m
in 1
20 m
m
min 40 mm
à
Insert the drain hose into a drain pipe with a
minimum diameter of 40 mm, or let it run into
the sink, making sure to avoid bending or
crimping it. Use the special plastic support that
comes with the appliance.
à
The free end of the hose must be at a height
min 50 cm max. 110 cm and must not be
immersed in water.
How to Drain Excess Water From
Hoses
à
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained
directly into the sink. It will be necessary to drain excesswater from hoses into a bowl or
suitable container that is held outside and lower than the sink.
Water Outlet
à
Connect the water drain hose. The drain hose must be correctly fitted to avo id water
leaks.
à
Ensure that the water inlet hose is not kinked or squashed.