Goddess DFE 947 DW9, Инструкция по эксплуатации

Страница: 65 / 76

ENG
ENG - 65 ENG - 64
TURNING ON THE APPLIANCE
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1) push them back. It is recommended to load the lower basket first, then the upper one (see
the section entitled “Loading the Dishwasher”). Pour in the detergent (see the section
entitled “Salt, Detergent and Rinse Aid”).
2) Insert the plug into the socket. The power supply is 220 – 240 V, AC 50 Hz, the specification
of the socket is 12 A, 250 V, AC 50 Hz.
Make sure that the water supply is turned on to full pressure. Close the door, press the “Power”
button, Press the “Program” button to select a desired “Wash cycle”. (See the section entitled
“Wash Cycle Table”). With a little force to ensure the door is properly closed.
NOTE: A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing “Power” button.
CHANGE THE PROGRAMME
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
entitled “ Fill in the Detergent”).
Press “Power” button to cancel the programme, and turn on it again ,then you can change
the programme to the desired cycle setting (see the section entitled “Starting a wash cycle…”).
NOTE: If you open the door when washing, the machine pauses and warning alarm rings. The
display shows the error message “E1”. When you close the door, the machine will keep on
working after 10 seconds.
The 6 programme lights show the state of the dishwasher:
A) One of the programme lights on → cycle running
B) One of the programme lights blinking → pause
NOTE: If all the lights begin to glimmer, that indicates the machine is out of order, please turn off
the main power and water supply before calling a service.
FORGET TO ADD DISH
A forgotten dish can be added any time before the detergent cup opens.
1) Open the door a little to stop the washing.
2) After the spray arms stop working, you can open the door completely.
3) Add forgotten dishes.
4) Close the door, the dishwasher will work after ten seconds.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher
The status indicator lights up,only in this case the programme has ended.
1) Switch off the dishwasher by pressing the Power button.
2) Turn off the water tap!
Open the door carefully. Hot steam may escape when the door is opened!
▪ Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down
around 15 minutes before removing from the appliance.
▪ Open the dishwasher’s door, leave it ajar and wait a few minutes before removing the dishes.
In this way they will be cooler and the drying will be improved.